1. Working space in front of electrical equipment, 600V or less, shall be _____ inches or the width of the equipment, whichever is greater.

2. In kitchens, receptacle outlets must be installed above all wall countertops _____.

wider than 36 inches

12 inches or wider

24 inches or wider

wider than 12 inches

3. The load for household electric clothes dryers in dwelling units shall be either _____ KW or the nameplate rating, whichever is larger for each dryer.

4.5

4. A single grounding electrode for the building service shall have a resistance of _____ or less, or be augmented by additional electrode(s).

35 ohms

25 ohms

30 ohms

15 ohms

5. Which of the following colors indicate an equipment grounding conductor?

white

gray

green w/ yellow stripe(s)

green w/ red stripe

6. The largest conductor allowed on an up-turned lug is _____ AWG.

7. When calculating feeder loads, signs shall be computed at a minimum of _____ volt-amperes for each required branch circuit.

1800

1200

1500

180

8. The minimum wire bending space at terminals for a single 3/0 conductor on a terminal is _____ where the conductor enters the enclosure on the opposite wall from the terminal.

5 inches

4 inches

8 inches

6 1/2 inches

9. While running non-metallic sheathed cable, the cable shall be supported within _____ of a metal junction box.

4 1/2 feet

12 inches

3 feet

18 inches

10. The 15-ampere, 125 volt receptacle outlet installed for the servicing of heating equipment shall be located on the same level and within _____ of the equipment.

10 feet

75 feet

50 feet

25 feet

Frank’s Test Quiz

News

Upcoming Events